Aerospace structural component with numerous precision bores

Pylon

Automatic forward and reverse chamfering of bores in pylons
Schematic diagram of the front and rear chamfers of a bore

Customer application

The pylon anchors the turbine to the aircraft wing and absorbs all the thrust forces. The pylon contains all the mechanical and electrical interfaces. The quality requirements are correspondingly high.

The numerous bores are only drilled once the pylon has been pre-assembled. This is carried out simultaneously from both sides on a twin-spindle machine. The plates, which consist of two different materials (layered structure), present a further challenge.

WorkpiecePylon
MaterialTitanium, 15-5 PH steel (layered structure)
Drill diameter8.0 mm
Chamfer diameter (forward)8.4 mm
Chamfer diameter, reverse9.8 mm
HEULE DEFA tool for chamfering the front and rear edges of bores

Solution

As these are blind bores, it is essential that the chamfers are machined to a high standard. To ensure the chamfers on the numerous bores are machined to a high standard, a tool system was required that could handle different diameters and materials, and machine in both forward and reverse directions. With the DEFA deburring tool, the component is machined from both sides simultaneously, thereby meeting all the specified requirements.

Close-up of a pylon component with precisely deburred bores

Customer benefits

  • Precise fibre diameter
  • High angular accuracy
  • In a single operation, in a single clamping, on both sides
  • Automation of the chamfering process
  • Customised tool design engineering (problem-solving)
  • Tool monitoring via spindle power
Download PDF