Hub-4 & DD Clutch

Description

This Asian customer out of the automotive industry was searching for the most cost-efficient way to drill the holes and to deburr them at the same time.

Application details

Application details

Bore diameter: Ø13.0 mm

Material: ADC 10 or 12 (Aluminium)

Machine: Magnix Tapping Center

Proposed solution

Proposed solution

HEULE recommended a customized VEX-P drilling tool with an integrated COFA deburring blade. The VEX standard range uses normally the SNAP tool for deburring or chamfering. The unevenness of the burr edge however required the COFA tool concept.

  • Tool type: GH-C-G-6578
  • Drill: P-P-C-1300-1D
  • Blade: GH-C-M-0083
  • Spring: W

Machining parameters:
Drilling Ø13.0 mm:
Speed: 250 m/min
Feed: 0.2 mm/rev.

Front & back deburring:
Speed: 45 m/min
Feed: 0.4 mm/rev.

Customer benefits

Customer benefits

The combination of drilling and deburring in one tool increases the productivity significantly. The result is up to the customer's excpectations.